TRANSWAVES fcma SOFT STARTER manufacturers- M/s Sakthi Power Innovatives an ISO 9001 : 2015 Certified Company manufactures Soft starters as per IS 5553 Part-3 and IEC- 60076-6 for reducing motor starting current. Our Soft Starter is step less reduced voltage start which ensures a constant low starting current, incremental voltage and torque to the motor to get smooth start. As the motor speed increases, the controller impedance decreases due to counter emf feed back to achieve constant incremental voltage torque for motor. This achieves very soft and smooth starting of load to Crusher, Compressor, Pumps, Centrifugal fan etc.This helps in optimizing the power source of transformer or generator capacity. Optimized power system also gives savings in capital, cost savings and revenue expenditure due to higher efficiency.
We also provide “The customized solution as per clientstechnical requirements”
Salient Features:
- Complete motor starting engineering solution as a part of pre-sales service to customer
- Extremely rugged in construction . Suitable for extreme weather conditions like dust and desert environment
- Low starting Current
- Starting of motor in gensets
- Starting of motor with limited power
- Built in bypass for full voltage during running
- No Harmonics generation - Zero Harmonics
- No forced cooling required
- Micro controller Digital Motor protection for Over current, Under current, Stall, Lock, Phase failure , Reverse phase, Asymmetry
- Protection relay for under voltage / over voltage
- Virtually no maintenance
- Easy to install and operate
Product Range
- Type of AC Motors:
- Synchronous Motors, Squirrel cage and Slip ring Induction Motor
- Power:
- 10KW to 20000 KW
- Voltage:
- 415V to 11 KV
Applicable Idustries
Water board, Irrigation Department, Sewage treatment plant Paper industry, Textile industry, Mining industry etc.
Specification Standards
- Operating voltage:
- 415V/3300V/6600V/11000/13800V, 50/60Hz
- Control voltage:
- II0VDC/240VAC.50Hz
- Auxiliary supply:
- 240 V AC
- Insulation:
- Class H/F
- Duty Cycle:
- 6 starts per/hr
- Method of cooling:
- Natural air cooled
- Enclosure:
- Floor mounting cubicle with Bottom/Top cable entry suitable for indoor installation
- Finish:
- Epoxy powder coated
Ordering Information
- The motor output in Kw, rated voltage, full load current, speed, power factor and resistance per phase
- Control supply voltage, Auxiliary supply voltage
- The motor torque speed characteristic
- The load torque speed characteristic
- The inertia of motor rotor as well as machine rotating parts.
